Tritium

Starting a charge session on a Tritium charger

1. Plug the cable into your electric vehicle. Wait for the charger screen to confirm it is ready for you to swipe a card or start from the app.

2. Select the charger in the app and press "start charge" on the desired connector or swipe your RFID card below the screen.

3. Wait for the charger to verify your start request.

4. Listen for a 'clunk' noise - this is the sound of the locking pins securing the cable so it cannot be unplugged. Power will start flowing to the vehicle after this point. 

5. To end the charge session, either swipe your RFID card in the same place as you did in step 1 or follow the steps below to end from the app.

Ending a charge from the app

1. Go to the 'Charge' page

2. Click on the lightning bolt

3. Click "end charge"

Alternative method to end a charge

1. Follow the vehicle manufacturers' process to unlock the charging cable from the vehicle (typically "unlocking" button via key fob) - please note this will not be an option if using the ChaDeMo connector.

2. Remove the charging cable from the vehicle.

Notes on Tritium Chargers

• Tritium chargers can be configured with different connector combinations so chargers at your site may not match the image below.